Cart 0
2006-2009 Dodge Ram 1500 Control Arms MEGA CAB ONLY (Stock Height-7" Lift)

2006-2009 Dodge Ram 1500 Control Arms MEGA CAB ONLY (Stock Height-7" Lift)

  • 21995

We are pleased to bring you our heavy duty tubular control arms for:

2006-2009 Dodge Ram 1500 MEGA CAB ONLY
(Stock Height-7"Lift)
Product Description: 
These is a complete set of (4) 2 upper and 2 lower brand new tubular control arms for the front of a 2003-2009 Dodge Ram 1500 MEGA CAB (ONLY WORKS ON MEGA CAB 1500'S)  4x4 at stock ride height all the way up to 7" of lift, just be sure to choose the correct amount of lift for your truck before purchasing or leave us a buyers not with your specs.  We are the original manufacturer of these, and have built them for other sellers on here for several years. We recently made the decision to offer them directly to the public but they have been available through other suppliers for a very long time. They are the correct length to correspond with a stock unmodified pickup keeping your front axle centered in the fender well as well as providing correct caster angles for drivability and optimal tire wear. These are sold in sets of 4, because you should replace both uppers AND lowers at the same time to maintain correct geometry. If you've installed any kind lift or leveling kit, you DEFINITELY need longer control arms! As you lift the truck, the angle of the arms increases, pulling it back in the wheel well.
*Please note that we have a 10 day handling time for Control arms. 5 Day handling time for Raw control arms. We our a build to order shop as we offer multiple variations of different kits.
 *Paying for custom color allows you any one stocking color or any one color Prismatic Powders carries. (Translucent Colors excluded due to lack of UV protection) Leave a buyers note at checkout with your desired color to avoid additional handling time.

So what sets our control arms apart from the competition us may ask? A lot does! We use DOM tubing in the construction of the arms AS WELL AS the sleeve the bolt passes through. Some of our competitors use a  thin wall, rolled over pipe similar to a shock sleeve which leaves a gap/seam. These arms undergo large amounts of pressure while accelerating speed and using your brakes. The competitors sleeves start to pull apart at that seam, which leaves a sharp edge inside the bushing. In no time the bushings start to shred from the inside out. Our sleeves are heavy wall DOM, with no seam, alleviating this very common problem. So you can relax, knowing you made the right decision with our control arms on your truck! 

Product Finish: 
These are finished in a heavy black powder coating which gives them elegance as well as extreme durability to the elements. We apply 10 mils of powder and bake at 400 degrees for no less than 20 minutes. The results are a finish that is capable of withstanding anything you can throw at it. 

This particular kit comes ready to install utilizing your stock hardware.

All of our products come complete with detailed step by step install instructions to ensure installation is a breeze. Average install time for this kit is 60-90 minutes.

Package Includes:

2 - Lower Control Arms (pre drilled)

2 - Upper Control Arms (pre drilled)

8 - Lower Bushings (prepressed into arms before shipment)

8 - Upper Bushings (prepressed into arms before shipment)

4 - Lower Sleeves (pre drove into bushings)

4 - Upper Sleeves (pre drove into bushings)

8 - Greaseable zirc inserts (not preinserted as they break in shipping)

2 - Instruction Sheet (1 for arms, 1 for zircs) 

We Also Recommend